|
|
|
Prevention is better than cure
Components ContinuedPressure
relief valve A plastic pressure relief valve is situated at the inlet of the inflatable collar to prevent over inflation. Under no circumstances should this valve be removed or modified. Serious damage could result and void your warranty. Stabilising
frame A semi-rigid plastic pipe frame is used to stabilise the flexible components of the dock when deployed down. It is also used to carry the mooring lines and closed cell buoyancy in the bow. The frame is joined at the bow by an active bow coupling and is attached to the flexible outer envelope by cable ties. This semi-rigid plastic pipe frame does attract barnacles with no ill-effect. Clean only if considered unsightly. Suspension
Buoy Robust
moulded styrene floats are attached to the stabilising frame, with a
predetermined length of rope, suspending
the dock just below the keel when in the down or open position. The Suspension Buoys do attract barnacles with no ill-effect. Clean only if considered unsightly. Flexible
Hose Connection Connects the Control/Pump Box to the Flexible outer envelope by means of hand tight O-ring connectors. Control/pump
box Comes fully assembled ready for use. Has a 12V power connection. Has
a water pump with float switch and an air pump.
Comes
in Manual, Automatic and Remote configurations.
See Options. See your supplier for service and maintenance of this component
|
|
© Sea Pen DryDoc Last updated 21 August, 2002 |
