Table of Contents.Lesson 1: Fundamental Drawing Skills and a Simple Simulation.
Lesson 2: Introduction to frequency and transient analysis.
Lesson 3: Configuring LT Spice and more Drawing controls.
Lesson 4: Locating, modifying, and installing vacuum tube models.
Lesson 5: Operating point of vacuum tube circuits. Introduction to stepping and plate curves.
Lesson 6: Using stepping to do frequency response of a tone control.
Lesson 7: Transient analysis of unregulated power supplies.
Lesson 8: Transient analysis of power supply regulators.
Lesson 9: Transient and frequency analysis of amplifiers with feedback.
Lesson 10: Lossless transformers.
DON'T FORGET TO SAVE THE DRAWING. Save it as Lesson 03.
If you can honestly checkoff each item on the list under the heading "What you will learn in lesson 3", you can go on to lesson 4, assuming I have written it by then.
This page last updated January 31, 2020.