Make sure ICImage is open during this section…(meaning minimize penpro, open icimage, minimize icimage then go on to step 1…)

1)     Maximize PenPro; Once finished with the estimate click the print button located on the bottom left of your screen.

2)     Click print setup.

3)     In the dropdown titled "name" select Kelly-Weston ICImage TIF.

4)     Click ok.

5)     Under "estimate options" make sure to bullet final print (meaning; have the black dot next to final print, not preliminary print).

6)     Make sure state disclosures reads whatever state you did the work in!!!!!!

7)     Click print.

8)       Click print again. (if you get an error stating you  have no generic print driver installed install a generic printer on your computer, if you do now know how to do this click here and left click the first question)