Sensory_Table_Instructions

Site hosted by Angelfire.com: Build your free website today!

Sensory Table Instructions

Note: These instructions are based on a finished height for 2-3 years olds. It may be
necessary to adjust the length of the (leg) pipes for a younger or older child.

Materials Needed:

1 1/4” PVC Pipes (purchase 3 X 5’ length pipes) (10’ pipes are cheaper but the 5’ fit in your car better.)

3/4” PVC Pipe (purchase 2 - 5’ length pipes)

1 1/4” PVC Joints: 4 - 90 degree Elbows, 4 Tees, 4 Caps

4 1” sheet metal screws

Hand Drill

Table Saw or Miter Box Saw (I just used a hack saw)

1” Hole Saw (goes on your drill)

80 Grit Sandpaper

Lacquer Thinner

11 Gallon Plastic Container with Cover

Rubber Hammer (to tap it all together)

Directions:
1.   Cut the PVC pipe to lengths indicated below.

1 1/4” pipes: cut 2 - 5’ pipes into 21 1/2”, 14 1/2”, 14” and 6”

cut 1 - 5’ pipe into 14”, 14”, 6” and 6”

3/4”pipes: cut 2 - 5’ pipes into 17 3/8” and 24 1/8”

2.   Drill a 1” hole 5” from each end of the 21 1/2” x 1 1/4” pipes. Drill through only one side.
3. Drill a 1” hole 3" from each end ofthe 6” x 1 1/4” pipes. Drill through only one side.   Center of the hole should be 3" from each end.
4. Sand any rough edges. Use lacquer thinner to clean the piping.
5. Put the elbows on the ends of the 14 1/2” x 1 1/4” pipes.
6. Lay pipes flat on the table.
7. Insert the 6” x 1 1/4” pipes into the elbows.
8. Position the holes upward.
9. Insert the tees on the end of the 6” x 1 1/4” pipes. The unit should lay flat on the table with the tee pointing up.
10. Set one unit aside.
11. Insert the 21 1/2” x 1 1/4” pipe into one tee. The holes drilled in the pipe must face inward.
12. Set the 17 3/8” x 3/4” pipes into the 1” holes drilled in the 21 1/2” x 1 1/4” pipe. It may be necessary to sand the inside of the hole to get the 3/4” pipe to fit.
13. Insert the other 21 1/2” x 1 1/4” pipe onto the 2 - 17 3/8” x 3/4” pipes.
14. Insert the 21 1/2” x 1 1/4” pipe into the open tee.
15. Insert the 24 1/8” x 3/4” pipes into the holes on the 6’ x 1 1/4” pipes
16. Take the pipe unit that was set aside and insert the tees and holes onto the unit on the table.
17. Turn the piping upside down, resting on the elbows.
18. Screw the 17 3/8 x 3/4” pipe to the 21 1/2” x 1 1/4” pipe at the joint. This will add stability.    Note: I haven’t done this on mine yet and it is still very stable.
19. Insert the 14” x 1 1/4” pipes into the tees making the legs of the table.
20. Put the caps on the ends of the 14” x 1 1/4” pipes.
21. Turn over and insert the plastic container.