| Previous | Toc |
7.
Route windshield washer spray hose, which
is now underneath cowl, through clip. Oper
ate cowl ventilator to
an open and closed po
sition to be sure of clearance with spray
hose. Then bend
clip closed to secure hose.
Keep hose close to dash and underneath
speedometer cable and push through grommet
on dash panel and attach to windshield wash
er valve assembly, (see figure 232).
8.
Adjustment of nozzle: Fill glass jar with
liquid through filler cap, (see figure 233).
Then slowly pump push button four or five
times to fill system. Using adjusting pin,
adjust the two small ball universal joint out
lets to spray in a "V" pattern from their
position on the cowl towards the upper out
side corners of the windshields. For best
performance we suggest hitting windshield
from approximately 1/2 to 2/3 of the way
across. Be sure all hose connections are
tight, as this unit exerts considerable pres
sure, (see figure
232).
Winter Use
The
use of the washer in freezing temperature
is not recommended. The
system should be
drained but if for any reason winter use should
be required, a special harmless all-season sol
vent can be secured from any authorized Gen
eral Motors Dealer at a nominal price, with
complete instructions on the bottle regarding
its usage.
Approximate Flat Rate Time .9 of an hour.
986545 ACCESSORY STEERING WHEEL
Procedure
for Installation
of
Accessory Steering Wheel
on All Model
Passenger Cars.
Figure 235
1. Before
removing equipment wheel note exact
position of wheel in straight ahead position.
With front wheels in straight ahead position,
remove equipment wheel.
2. Place
Accessory Wheel on shaft with spokes
in horizontal position. Replace shaft washer
and nut and tighten nut securely.
3.
The adjustment of the horn blowing ring is
set at the factory; no further adjustment is
necessary.
4.
Fit locating tab of hub cap assembly into
slot in horn blowing ring and press cap in
to position.
Approximate Flat Rate Time .2 of an hour.
| Previous | Toc |
