Here I attached the engine servo.

Here I cut a hole in the hull for the air splitter so a portion of the thrust air will go into the skirt.

In this shot I attached the thrust duct that I made out of plain old cardboard, That wire is a coat hanger to help give stregnth and support to the duct.

Here it is ready for the skirt with the taped up hull shining in the sun, isn't it cool looking?

Here I attached the rudder servo. All the rudder is is a peice of plywood attached to a drinking straw. I then ran a dowel through the straw and into the hull to attach it to the craft.

Here I am attaching the skirt.

Here it is ready to fly!

Here is detail of the inside. The little black box behind the engine is the reciever and the servo is to the left of that.

here it is flying around at about 12 mph.

Here is another action shot.