You are logged in as erlich
Question 1:
What technique does 802.1q use to implement VLANs?
A. Grouping
B. Filtering
C. Source bridging
D. Frame tagging
Question 2:
How can access be controlled on a secured VLAN?
A. Station address
B. Protocol types
C. Application types
D. All of the above
Question 3:
What term describes all nodes on the same VLAN ID that are attached to the same switched port?
A. Dynamic
B. Static
C. Port-centric
D. Static-centric
Question 4:
According to the IEEE, what is the acceptable way to implement VLANs?
A. Grouping
B. Filtering
C. Source bridging
D. Frame tagging
Question 5:
VLANs, along with routers, establish which of the following?
A. WANs
B. LANs
C. Broadcast domains
D. Collision domains
Question 6:
Which device is used to reduce or eliminate broadcast related problems?
A. Bridges
B. Routers
C. Passive hubs
D. Active hubs
Question 7:
What is a VLAN used to create?
A. Autonomous systems
B. Broadcast domains
C. Network Sectors
D. Virtual sections
Question 8:
Dynamic VLANs can be based on which of the following?
A. MAC addresses
B. Protocol type
C. Logical addressing
D. All of the above
Question 9:
Which of the following do VLANs use to make filtering and forwarding decisions?
A. Packets
B. Frames
C. Presentation header
D. Network design
Question 10:
A VLAN makes up a switched network that is logically segmented by all of the following
EXCEPT
:
A. Collison domains
B. Functions
C. Applications
D. Project teams
Question 11:
Frame tagging functions at what OSI layer?
A. 2
B. 3
C. 1
D. 4
Question 12:
What is the term used when switch ports are automatically assigned to a VLAN?
A. Dynamic
B. Static
C. Port-centric
D. Default
Question 13:
Which of the following VLAN types require changes by the network administrator but are easy to configure, and straightforward to monitor?
A. Dynamic
B. Static
C. Cut-through
D. Store-and-forward
Question 14:
Frame tagging places a unique identifier in the header of each frame as it is forwarded across the network __________.
A. microsegment
B. LAN
C. backbone
D. WAN
Question 15:
What is the term used when ports on a switch are administratively assigned to a VLAN?
A. Dynamic
B. Static
C. Default
D. Polled
Question 16:
Users may be reassigned to different VLANs using which of the following?
A. Hubs
B. Software
C. Routers
D. Bridges
Question 17:
What is an effective preventative measure used with segmentation to prevent broadcast related problems?
A. Firewalls
B. LANs
C. WANs
D. Bridges
Question 18:
A VLAN is based on which type of grouping?
A. Logical
B. Physical
C. Star
D. Ethernet
Question 19:
When logically segmenting your network with VLANs, what type of device do you need to ensure proper communication between the VLANs that are created?
A. Switch
B. Bridge
C. Hub
D. Router
Question 20:
Which technique examines particular information about each frame?
A. Latency
B. Frame resolving
C. Frame filtering
D. Store and forward
Question 21:
What is a benefit of using VLANs?
A. Extended collision domains
B. Increased administration
C. Multiple cable runs
D. Tighter network security
Question 22:
The smaller the VLAN, the smaller the number of users that are affected by which of the following?
A. Packet filtering
B. Switch latency
C. Framing
D. Broadcasts
Question 23:
What would be the preferred type of link of a VLAN backbone?
A. slow serial
B. low capacity
C. 56 Kbps
D. High bandwidth
