
          Ŀ
                   NEC P3 Reprogramming Instructions           
          

The package contains the wiring diagram, instructions and chipping software.

You will need :
             
Lager
1N4148 Signal Diodes  (2 off)
25 pin D Plug with metal casing
P3 car saver unit
              

Here Goes :

Drink the lager.
OK, so it's not needed but it makes the job less boring, right ?

Make sure that when you are buying the car saver / lighter adaptor unit, all
the pins on the "plug" end are visible - ie don't get one that just has two
pins showing - these are *tricky*.. Take your snippers or knife and chop the
lighter plug attachment off the end of the cable.

From the cut end of the cable, locate the wires corresponding to the pins on
the P3 plug as shown below, and solder them carefully onto the relevant pins
on the D plug, not forgetting the diodes (and get em the right way round!)

Lastly assemble the casing ...


                            Ŀ
                              WIRING DIAGRAM  
                            

25 Pin D plug on LPT1                                   P3 plug on other end
=====================                                   (looking into plug)

Pin 25  black Ŀ
Pin 15   red  Ŀ  
Pin  6 |< diode |Ŀ                                              
Pin 13  white Ŀ    
                                                  ||  [ ][ ][ ][ ][ ][ ]
                                           aerial <>
Pin  3 |< diode |Ŀ                           ||  [ ][ ][ ][ ][ ][ ]
Pin 12  brown 


Note the correct diode protocol :  Cathode --|<    |-- Anode
The wire colours may also be different but just keep the pins the same..

Ok, so that's all done - connect it all up and run the software..

Enter the ESN no. to program the phone with. Next you must enter the phone
number. (Note: The software requires you enter the phone number in the
format 0850 etc, and not the provider prefixes like 2342)

Unfortunately the software does not yet support Cellnet 0585 numbers, but
you can get round this by entering another valid prefix number, then
entering test mode on the phone and change the MIN in #71 to support 0585.
Simple!

Lastly, choose a 4 figure lock code and then you're ready to go. Enter Y at
the "Reset" prompt and your phone should be programmed and ready to use.

Happy Chippin'

