NEC P-200 & P-300 Programming
The the P2 (P200) and P3 (P300) can be reprogrammed by means of a cable
which attaches to your computer's parallel port and the phone's accessory
connector. All the software below requires this cable. NAM programming
is done through test mode. Several programs
below can put the phone into this mode.
P3 PROM, modified to allow ESN change from
the keypad. Unknown if this will work on the P2.
Note: using the programs below may require you to translate ESN formats.
Several programs are available:
- esnnecp2 is a basic program that I wrote
when I didn't have any better one. not accurate, good for academic interest
in how its done.
- ESNconv by Spectrum Anarchy. Hex,
AMPS (US) and TACS (U.K.)
- esnv33 by Uncle Gazzer. Hex, Amps,
Tacs.
VodaClone
D.C.L. & Skios series ver 0.9
- p3mem reads / writes phone's memory to /from
file
- p3esn writes an ESN given on command line (in
U.K. format) to phone.
- p3test puts the phone into test mode.
- Instructions for the three above programs
Ricochet
- p3 writes ESN to phone & leaves it in test
mode. (expects ESN in U.K. format)
- p3-read puts phone into test mode and makes
it display ESN in USA (AMPS) decimal format
