supplies:
-
a screw driver
-
clear packing tape
-
a printed picture of Placebo
-
a pencil or this template
| directions:
- Use the screwdriver to unscrew the plastic plate covering your lightswitch
- Print & cut out the template provided above. Or make your own by tracing your switchpate cover with your pencil onto a piece of paper.
- Use the template to find a good picture of Placebo* (or the band member of your choice). The parts of the template that are X'ed will not be able to be seen, but make sure that the picture is about a half an inch bigger all around to allow for the edges to fold under. Be sure that you don't choose a picture where the band's faces are in the center or a picture that's too much bigger than the plate cover.
- Carefully place the picture on top of the plate cover and fold the edges of the pic under and around the switch plate.
- Use clear packing tape to cover the picture to make it water-resistant and help the picture to be stronger.
- Use something sharp the pierce through the pic where the screw holes are. cut an X in the center where the light switch will come through, but don't the square out! fold the edges of the X in so it will be more secure.
- Screw the newly covered switch plate back onto the wall.
- Sit back and admire your pretty Placebo lightswitch plate.
|
