For Sale

1984 Pontiac Grand Prix

(with light weight Monte Carlo nose & hood)

Click to see more pics.

Chassis:

• All new parts installed on frame, including all bushings, bearings, seals, steering, suspension and brake parts.
• Body removed from Frame and solid mounts welded on.
• Full NASCAR type cage installed by MWR.
• 16 Gallon fuel cell with rollover valve in vent and manual shutoff valve.
• Aluminum dash with Autometer gauges (Memory Tach, oil pressure, oil temp, water temp and trans temp).
• Adjustable spring spacers installed front & rear.
• Stock Car Products upper front A arms.
• Pro and QA1 shocks in stock location.
• 1 & 1/4 stock sway bar in urethane bushings.
• US Brake brake pads (race compound).
• US Brake front hubs.
• All stainless braided brake lines.
• CJR Products NASCAR power steering pump with braided lines & aircraft fittings.

Engine:

• 350 Chevy block checked Magnifluxed, machined for performance & durabilty. Bored 60 over.
• All rotating assemblies fully balanced and blueprinted.
• SpeedPro flat top pistons with moly ring package.
• Clevite 77 race bearings (Crank, Rods & Cam).
• Lunati cam kit (cam, lifters, springs & retainers).
• Melling high volume-high pressure race oil pump (oversize 3/8 flanged and bolted pickup tube, not pressed on)M10555.
• Moroso Sportsman series oil pan and pickup for flange type Melling pump .
• Lightweight 8 inch harmonic balancer.
• Billet aluminum underdrive pulleys.
• Fel-Pro gaskets throughout.
• Stock rods checked, magnifluxed, prepped & resized.
• CircleTrack calibrated distributor with vac advance lockout, weights and all new electronics (regulator, coil, etc.).
• 63 Vette 461 casting (double hump/fuelie) heads. Fully rebuilt= hot tanked, oven baked, shot rolled and magnifluxed. Machined with all new hardened seats, bronze guides, screw in studs and guide plates.
• Trick Flow Stainless Steel valves (1.94 &1.50).
• Harland Sharp 1.52 roller rockers.
• All ARP fasteners.
• Edelbrock 2101 intake.
• Blake Holley 350 carb.
• Edelbrock high volume bottom exit fuel pump with stainless braided lines and aircraft fittings.
• Dynatech headers.
• Dr. Gas x pipe exhaust system.
• Power Master lightweight starter.
• Remote oil filter mount with braided stainless lines & aircraft fittings.
• Aluminum radiator with electric fan.
• One wire alternator.

Transmission:

• GM 350 Turbo.
• Fully rebuilt with race TCI kit (all bushings, seals etc.).
• Aluminum vent tank.
• B&M Z Gate ratchet shifter.
• Aftermarket cooler with braided stainless lines & aircraft fittings.

Third Member:

• Stock rearend housing per rules.
• Moser axles.
• Richmond Gear 3.42 ratio.
• Stock aluminum brake drums.
• All new brake hardware (wheel cylinders, shoes, etc.).
• Rebuilt stock G-80 posi unit.
• Drive shaft rebuilt and balanced.

Safety:

• All safety gear purchased end of 2004.
• Simpson sternum 5 point belts.
• Kirkey Deluxe series aluminum seat with right AND left head, shoulder & thigh supports.
• Remote FireBottle fire suppresssion system.
• All bars within driver's reach fully padded.
• Steel plate on outside of driver's doors bars (top to bottom, front to back)per SNS rules.
• Bicknel aluminum steering wheel quick release.

Also Available: (Click pictures for more info)

1995 Chevy C-3500 Siverado Extended cab dually

2001 racecar trailer ""






richardholden_3@angelfire.com