EAGLE TECHNOLOGY RX-NET 810-114-001 (REV.E, F, AND G) NIC Type ARCnet Transfer Rate 2.5Mbps Data Bus 8-bit ISA Topology Star Wiring Type RG-62A/U 93ohm coaxial Boot ROM Available [Image] NODE ADDRESS Node SW1/1 SW1/2 SW1/3 SW1/4 SW1/5 SW1/6 SW1/7 SW1/8 0 - - - - - - - - 1 On On On On On On On Off 2 On On On On On On Off On 3 On On On On On On Off Off 4 On On On On On Off On On 251 Off Off Off Off Off On Off Off 252 Off Off Off Off Off Off On On 253 Off Off Off Off Off Off On Off 254 Off Off Off Off Off Off Off On 255 Off Off Off Off Off Off Off Off Note: Node address 0 is used for messaging between nodes and must not be used. A total of 255 node address settings are available. The switches are a binary representation of the decimal node addresses. Switch 8 is the Least Significant Bit and switch 1 is the Most Significant Bit. The switches have the following decimal values: switch 8=1, 7=2, 6=4, 5=8, 4=16, 3=32, 2=64, 1=128. Turn off the switches and add the values of the off switches to obtain the correct node address. (On=0, off=1) BASE MEMORY AND I/O BASE ADDRESS Memory Base I/O JP1 JP2 JP6 JP7 C000h 350h Pins 1 & Pins 2 & Pins 1 & Pins 2 & 2 3 2 3 CC00h 300h Pins 1 & Pins 1 & Pins 1 & Pins 1 & 2 2 2 2 D000h 2E0h Pins 2 & Pins 2 & Pins 2 & Pins 2 & 3 3 3 3 DC00h 2F0h Pins 2 & Pins 1 & Pins 2 & Pins 1 & 3 2 3 2 Note:Pins designated should be in the closed position. BOOT ROM Setting JP3 » Disabled Open Enabled Pins 1 & 2 Closed FACTORY CONFIGURED SETTINGS Jumper Setting JP4-JP5 Open INTERRUPT REQUEST IRQ JP8 JP9 JP10 JP11 » 2 Open Open Closed Open 3 Open Open Open Closed 4 Closed Open Open Open 7 Open Closed Open Open