PURE DATA, LTD.

PDI508PLUS-F

NIC Type      ARCnet
Transfer Rate 2.5Mbps
Data Bus      8-bit ISA
Topology      Linear Bus
Wiring Type   200 m fiber optic cable
Boot ROM      Available

[Image]

                                CONNECTIONS

               Purpose                              Location

   SMA 905 Receive Connector (gray)                   CN1

  SMA 905 Transmit Connector (black)                  CN2

                        CONFIGURATION MEMORY CLEAR

                 Setting                                 JP1

  »            Normal operation                         Open

       Clear memory of all addresses and               Closed
                   settings

                             INTERRUPT REQUEST

        IRQ               JP2A               JP2B              JP2C

  »        5             Closed              Open              Open

           6              Open              Closed             Open

           7              Open               Open             Closed

                           TIMEOUT CONFIGURATION

    Response Time      Reconfiguration Time        JP3           JP4

  »       74.7µs              840µs               Open           Open

         283.4µs              1680µs              Open          Closed

         561.8µs              1680µs             Closed          Open

         1118.6µs             1680µs             Closed         Closed

                              CARDS INSTALLED

  Card number        JP5A           JP5B           JP5C          JP5D

  »       1          Open           Open           Open         Closed

          2          Open           Open          Closed         Open

          3          Open          Closed          Open          Open

          4         Closed          Open           Open          Open

  Note:If there is only one NIC installed in a system, set this option to
  the "1" position. If this NIC is the second card to be installed in the
  system, set this option to the "2" position, and so on.

                             DIAGNOSTIC LED(S)

     LED         Color          Status                 Condition

    LED1          Red        On/Blinking       I/O bus activity detected

    LED1          Red            Off              No I/O bus activity
                                                       detected

    LED2         Green            On           Network activity detected

    LED2         Green           Off              No network activity
                                              detected or bad connection

                            MISCELLANEOUS NOTES

  Software that is supplied with the card must be run in order to fully
  configure the card.