HURRICANE-4 MPI SYSTEM Prices.

HURRICANE-4 MPI SYSTEM - What you get and what it costs:

• We pefer to sell our HURRICANE-4 MPI as a complete system as listed below (this way we know it will work and you don't have to hunt for parts!).
• HURRICANE-4 MPI SYSTEM includes two kits:
• (A) MPI4-PRO kit with:
• MP-PRO-4AH aluminum four injector manifold.
• Billet aluminum fuel rail with AN fittings (inlet and return).
• TB-PRO70 throttle body.
• Four fuel injectors matched (75lb).
• t-stat and housing.
• manifold gasket, TB gasket.
• Water temp sensor.
• TPS sensor.
• Vaccum Fittings.
• Throttle cable.
• THE MANIFOLD,TB. INJECTORS, SENSOR, and FUEL RAIL ARE PRE-ASSEMBLED and WIRED!
• (B) MPI-FC-PRO Fuel controller for HURRICANE-4 MPI with :
• FC-1 fuel injection controller. This is programmed ready to go, but changes can be made with software or the optinal TD-1 handheld tuner/display($195.00).
• Wiring harness for fuel injection system made to plug into the MPI4-PRO for the Conquest.
• Standard map sensor (good to 20 psi).
• WIRING SUPPLIED IS VERY COMPLETE AND EASY TO INSTALL MOST EVERYTHING JUST PLUGS IN.
• HURRICANE-4 MPI SYSTEM (A and B above) price is $2150.00 plus shipping. If you are using the stock ignition add $49.00 for the igntion pickup adapter(not needed if you have a MSD 6A,AL,ect.).
• You may buy MPI4-PRO kit and add the MPI-FC-PRO when ready.
• All parts we make( computer, manifold,ect) covered for one year on defects, sensors are 30 days.
• All of our systems can be used with the stock ignition system and vacuum ports are installed.

Go to:

PLACE ORDER
Back to HURRICANE-4
Home

Our kits and systems are very complete, offer very good preformance and looks at the best prices. Plus our systems are preprogramed and ready to run after installed. The other item you would need for the MPI is a fuel injection fuel pump with flow for the hp of the engine. Our goal is to have easy to install, ready to run systems for all levels of performance( to 1000hp+). We program the controller for your setup, so the car can be driven after the system is installed, but changes can be made if needed. We are able to keep our prices low because we design and make the computer,manifolds, wire harnesses, and other parts. The computer hardware including the printed circuit board was design by us. We pre-program it for our systems. All of our systems are tested and on running cars.