Mounting and Guying

1. After selection of a safe position of the mount, position anchor points for the guy wire as shown in figure 1.

• 
  2. Attach guy wire (4 places recomended) to the lowest guy ring and wrap wire at least 6 turns around itself, see figure 2.
  3. Insert lower section of Telescoping Mast into mount,making sure the mast is in vertical position, and insure the guy wires at the anchor points.
  4. After the guy wires have been secured for the lower section, a ladder may be leaned against the mast and tied in place.
  5. Mount your antenna to the upper mast section, (1-¼ Dia.) and secure transmission line with standouts.
  6. Raise the upper section of the mast with the antenna until it reaches its stop. Tighten clamp with hex bolt to secure upper section in place.
  7. Using a person at each anchor point to hold guy wires, raise each section and secure in place as indicated in step 6. (working from the smallest dia.(1-¼) to the largest.)
  8. After Telescoping Mast is fully extended, draw the guy wires taut (keeping the mast perfectly vertical) and secure to anchor points.

To know more about the masts, click ahead

CB Radio Banner Exchange