Game Axe NES Supporter

The second solution is to make what I call (and which I invented) a Game Axe NES Supporter (copyright).

First, take some hard cardboard like the back of a notepad.

Cut a portion which measures 5.25 inches by 11 inches.

Fold in .5 inches on either side so the cardboard now measures 4.25" x 11".

Cut the folded portion approx. 2" up on both sides and cut up to remove the excess.

Now bend the top 4" down so the entire support measures 4.25" x 7".

Push this into the port on top of the Game Axe below the connector.

Connect the NES cartridge and converter as usual.

Voila! It's supported and movement will not screw up your game! Sounds complicated, but its actually quite easy.

Please let me know what you think by sending me email at hwong3@lycos.com.

Thanks, I appreciate all comments, suggestions and improvements!