Chapter 3 Exam
Question 1:
Which device is used to reduce or eliminate
broadcast related problems?
A. Bridges
B. Routers
C. Passive
hubs
D. Active
hubs
Question 2:
How can access be controlled on a secured VLAN?
A. Station
address
B. Protocol
types
C.
Application types
D. All of the
above
Question 3:
A VLAN is based on which type of grouping?
A. Logical
B. Physical
C. Star
D. Ethernet
Question 4:
Which of the following do VLANs use to make
filtering and forwarding decisions?
A. Packets
B. Frames
C.
Presentation header
D. Network
design
Question 5:
What is the term used when ports on a switch are
administratively assigned to a VLAN?
A. Dynamic
B. Static
C. Default
D. Polled
Question 6:
What is a VLAN used to create?
A. Autonomous
systems
B. Broadcast
domains
C. Network
Sectors
D. Virtual
sections
Question 7:
What is the term used when switch ports are
automatically assigned to a VLAN?
A. Dynamic
B. Static
C.
Port-centric
D. Default
Question 8:
What term describes all nodes on the same VLAN
ID that are attached to the same switched port?
A. Dynamic
B. Static
C.
Port-centric
D.
Static-centric
Question 9:
The individual ports of a non-intelligent hub can
be assigned to how many VLAN(s)?
A. Three
B. Two
C. One
D. None
Question 10:
What is an effective preventative measure used
with segmentation to prevent broadcast related problems?
A. Firewalls
B. LANs
C. WANs
D. Bridges
Question 11:
According to the IEEE, what is the acceptable
way to implement VLANs?
A. Grouping
B. Filtering
C. Source
bridging
D. Frame
tagging
Question 12:
Frame tagging places a unique identifier in the
header of each frame as it is forwarded across the network __________.
A.
microsegment
B. LAN
C. backbone
D. WAN
Question 13:
Dynamic VLANs can be based on which of the
following?
A. MAC
addresses
B. Protocol
type
C. Logical
addressing
D. All of the
above
Question 14:
Frame tagging functions at what OSI layer?
A. 2
B. 3
C. 1
D. 4
Question 15:
What technique does 802.1q use to implement
VLANs?
A. Grouping
B. Filtering
C. Source
bridging
D. Frame
tagging
Question 16:
A VLAN makes up a switched network that is
logically segmented by all of the following EXCEPT :
A. Collison
domains
B. Functions
C.
Applications
D. Project
teams
Question 17:
VLANs, along with routers, establish which of
the following?
A. WANs
B. LANs
C. Broadcast
domains
D. Collision
domains
Question 18:
What would be the preferred type of link of a
VLAN backbone?
A. slow
serial
B. low
capacity
C. 56 Kbps
D. High
bandwidth
Question 19:
The smaller the VLAN, the smaller the number of users
that are affected by which of the following?
A. Packet
filtering
B. Switch
latency
C. Framing
D. Broadcasts
Question 20:
Which of the following VLAN types require
changes by the network administrator but are easy to configure, and
straightforward to monitor?
A. Dynamic
B. Static
C.
Cut-through
D.
Store-and-forward
Question 21:
Which technique examines particular information
about each frame?
A. Latency
B. Frame
resolving
C. Frame
filtering
D. Store and
forward
Question 22:
What is a benefit of using VLANs?
A. Extended
collision domains
B. Increased
administration
C. Multiple
cable runs
D. Tighter
network security
Question 23:
Users may be reassigned to different VLANs using
which of the following?
A. Hubs
B. Software
C. Routers
D. Bridges
Question 24:
When logically segmenting your network with
VLANs, what type of device do you need to ensure proper communication between
the VLANs that are created?
A. Switch
B. Bridge
C. Hub
D. Router
