What I'm about to tell you is top secret. This is the assembly instructions for the Sniper.
This is the matirials that you will need in order to make one. See list below.
- 1 cheap mechanical pencil.
- Scissors
- 3 rubberbands (have to be bigger than 1 inch radius but no bigger than 2 inch radius)
- 1 medium size paper clip
Now that you got the assembly materials heres how you put it together.Look at Illustration below
- First cut the tip off the pencil till the barrel of the body is equal width all the way down to the cut of cap or tip.
- Then you have two pieces. The one that goes inside the body and the body.
- Next make sure you can move the pieces easily in and out.This is very important. Also make sure you can fit a BB into the body.
- After that Take a Rubber Band and cut it so it is one long strand.
- Then you take the paper clip and unfold it till you have just a long piece of wire with the smaller hook left unbent.
- Next you take the rubber band and devide it equelly on both sides and put it in the hook.
- Then you slip the long part of the paper clip into the back end of the second tube where the eraser goes.
- you next slip the tube into the body and then pull the two strands of rubber bander on both sides to the sides of the body and take the two remaing rubber bands and rap them around the body with the 1st rubber bands remains and pull it taught. Its pretty simple.
Now that you got that right start shooting things but remember to not shoot people because it wont fit good if you have to pay the medical bills for shooting someones eye out.
Now to go back to my homepage,Click Here!
