1. Remove the front signal lights, both left and right side. There are two screws holding them on, take out the outside screw of each one, then the light will pull out. disconnect the bulb by turning the harness 90 degrees and pulling it out. Now you can just put these to the side.
2. After removing the signal lights, if you look through the opening, you should see 2 (I believe 14mm)bolts behind each opening.
3. Before taking out those 4 14mm bolts, first go into bolt wheelwells, and right where the bumper attaches to the inner wheelwell, you should see two phillips screws on each side of the car. Take out these 4 screws.
4. Now you can go ahead and take out the four 14mm bolts behind where you took the signal lights out.
5. If you have foglights or any other electrical accessories that are attached, disconnect these. Now you can just pull the bumper straight off towards the front of the car.
1. Inside each of the rear wheelwells, where the bumper attaches, you should see two phillips screws on each side, facing the back of the car. Remove these four screws from the two sides.
2. Remove the lower covers from the trunk floor that are on top of the spare tire so that you have access right down to the bottom of the floor.
3. Next, you'll have to go under the car. Look close to the back of the car and you should see two splash guards on each side. Take these off and it should reveal the two lower mounting nuts for the rear bumper.
4. Use a 14mm socket or wrench to remove these two nuts, they shouldn't be to hard to take off since they were covered by the splash guards, although some may still give you some trouble.
5. After you get those two lower bolts off, go back into the trunk area. You should be able to see two more 14mm nuts down close to the floor. If they're the original nuts, they will look just like the ones you just took off from the bottom of the car. Take these two nuts off.
6. Now you should be able to pull the rear bumper back enough to disconnect the two wires for the license plate lights. Disconnect these two wires, then you can pull the bumper off the rest of the way.
