1. Depress spring and remove tray from re
tainer.

2. Install retainer with four screws furnished
through the four holes provided in bottom
flange of instrument panel.   (See figure 153).
3, Replace ash tray.

Approximate Flat Rate Time ,2 of an hour.

986553 ARM REST

Procedure for Installation of Arm Rest
on All Model Passenger Cars.

3. Attach arm rest with sheet metal. screws
and tighten securely as shown in figure 157.

Figure 157

Approximate Flat Rate Time .]. of an hour.

Figure 155

1. Holes for attaching arm rest are located
behind trim panel as shown in figure 156.
2. Probe for these holes and pierce trim panel
for screws.

Figure 156

986154 ARM REST - TRUCK

Procedure for Installation of Arm Rest
on 3000-4000-5000-6000 Model Trucks.

Figure 158

1. To locate holes in metal under right-hand
door trim panel, locate template as indicated
in figure 159, and cut holes in trim panel.

2. Loosen trim panel lower screws and see
that spacer is in place below rear attaching
hole as shown in figure 159. If not, install
spacer furnished. A little rubber cement on
the spacer will aid in keeping it in place
until arm rest is attached with screws fur
nished.