| Previous | Toc | Next |
4.
Connect lead from lamp to battery terminal
on voltage regulator.
5.
After installation, the proper position of the
lamp should be checked, lower the hood
within eight inches of closed position, at
which point light should go off.
6.
If it does not, bend the bracket downward
slightly.
TRUCK
Installation
procedure is the same as for the
passenger car except location of wire. See fig
ure 130.
1. Attach
lamp at right-hand of flood top panel
rear reinforcement, using existing attaching
parts as shown in figure 130.
2.
Allow sufficient slack in wire to raise hood
fully.
3.
Install clips under nut and lock washer on
ends of brace rods, pinch tight on wire.
Approximate Flat Rate Time .1 of an hour.
986299 RIGHT-HAND TAIL LAMP
Procedure
for Installation of
Right-Hand Tail Lamp
on Model 3000-4000-5000-6000 Trucks.
| Previous | Toc | Next |
