| Previous | Toc | Next |
6.
Splice right-hand fog lamp wire into left
hand fog lamp wire at the left-hand end of
radiator tie bar as shown in figure 113. Sol
der and tape splice.
7.
Mount fog lamp switch in instrument panel
by locating hole
in line with windshield wiper
switch, ignition and choke, by measuring
1-27/32 o£ an inch to the left of windshield
wiper switch. Drill 13/32 inch hole in in
strument panel as shown in figure 114,
8,
Assemble terminal and sleeve
to left-hand
fog lamp wire and connect to terminal of
switch marked "ROAD," connect fuse holder
assembly to Accessories Junction Block (see
figure 114), the other end to terminal marked
"BAT" on fog lamp switch. Place the other
lead wire to terminal marked "TAIL" on
fog lamp switch and the other end to the
tail light terminal of light switch as shown
in figure 114.
9.
Mount switch in instrument panel with nuts,
washers and knob provided. Make sure that
Knob lettering is in horizontal position.
Lamp Aiming Procedure
the
car and draw a vertical line at this
point.
Place a vertical line the same distance to the
left or right of center as the lamp is from the
center of the car. Aim the lamp so that the
top of the beam is at the horizontal line, and
centered sideways on the axis of the lamp, re
gardless of its position to the left or right of
the center of the car. After the lamps has been
properly aimed, tighten the lamp nuts securely.
(See figure 115,)
Approximate Flat Rate Time 1 hour.
986524 FOG LAMPS
Procedure
for Installation of Fog Lamps
on All Model Trucks.
1.
Locate two holes in stone guard by measur
ing from the centerline of the truck 16-1/2
inches to the outer ends of the stone guard.
Measure 1-7/8 inches from front edge of
stone guard and scribe centers with the
16-1%2 inch measurement, center punch and
drill two 13/32 inch holes in stone guard,
see figure 116.
Place
car on a level stretch with a light col
ored surface or aiming screen twenty-five
feet
{25') ahead.
Draw a horizontal line on this
surface four inches (4") below the level
of the
fog lamp center. Sight through the center of
the rear window of the car over the hood orna
ment to determine the vertical center-line of
NOTE:
THIS IS FOR TRUCKS WITHOUT
GRILLE GUARD. See chart for measure
nnents with grille guards in figure 116.
2. Assemble
fog lamps to brackets loosely and
mount to stone guard, as shown in figure
118, tighten brackets securely leaving lamps
loose for aiming.
Figure 115
| Previous | Toc | Next |
