| Previous | Toc | Next |
1_
The horns included in this package are
equipped with brackets for mounting under
the hood on the eiagine dash. Figure 1.08
shows the layout of the installation and the
location of the
four 9/32" diameter holes
and the three 3/16" diameter holes in rela
tion to the three existing hales in the en
gine dash. NOTE TYPE OF HEATER USED
FOR PROPER HORN LOCATIONS. See fig
ure 148, Drill the four 9/32" diameter horn
mounting holes as shown in figure 108.
Loosen the dash mat fasteners
and install
the reinforcements under the dash mat
against the panel on the passenger
side of
the dash. Fasten the horn mounting
brack
ets on the projecting studs with the nuts and
lock washers furnished. See figure 108.
2.
On the lower mounting stud of the upper
horn bracket and on the upper mounting stud
of
the lower horn bracket assemble the
ground lead clips. (Check Heater installation
and note figure 108.) First, place one of the
lock washers next to the horn mounting
bracket, then the ground lead clip, followed
by
the second lock washer and nut, See
Section "A-A," figure 148. This places a
shakeproof washer on each side of the ground
lead clips to insure a goodground connection.
3.
Mount the horns as shown on illustration
(note position of projectors) with the low
note horn above the high note horn and fas
ten securely with nuts and lock washers
furnished. The horns must he rigidly mount
ed or the tone will be affected.
4. To
mount the horn relay, drill the two 3/16"
diameter holes as shown and secure relay
in place using two of the self-tapping screws
included in the package. Assemble the third
terminal clip of the ground lead under the
head of the relay mounting screw as shown.
On vehicles using Recirculating Heater, place
center clip of ground lead on Heater mount
ing stud as shown in the dotted line enclosed
area on the illustration. This insures a good
ground connection for the horns. Onvehicles
using Recirculating Heater, place one of the
horn lead clips and lead from upper horn
under this screw as shown in the dotted lines
enclosed area.
| Previous | Toc | Next |
