Instructions:
Obviously the soda can should be empty, so bend it in half and then bend it back the other way. The can should kinda look like an hour glass.
The mouth piece will be where you drink from, so turn the can over so that part is on the bottem.
On the top of the can, poke holes in a circle near but not on the base of the can using the knife or needle. The holes should be small. This is where you put your bud.
On the side of the can you can cut another hole about the size of a pen for an optional shotgun near, but not on the same part as the mouth piece.
All the holes cut or poked on the can should be on the thinner sides on the can, there shouldnt be any holes cut on the top (where the mouth piece is) or the base of the can where the thicker metal is.
*You may find the diagram exceptionally helpful if the instructions seemed too complicated for this particular project.
