Custom Fabrication (Bumpers)

Mike Pickel Custom 4x4 Fabricator

Contact me via e-mail for more information

Here is some of his work...

Mike uses good quality products, he reinforces the bumper on the frame and it is all winch ready!

Mike's purpose for creating this bumper is to allow an easier way to have a multi-mount, he has developed a remarkable system that can be used for winching or tugging. The D-rings are bolted through metal 1" thick that is then welded to the bumper than bolted to the frame. This bumper weighs in at right under 100lbs. It is the ultimate 4x4 necessity!

The optional winch application as seen on the Bronco is set up instead of having a 2" receiver that can become unbalanced when winching, Mike uses his own idea of a tray with two tubes that are inserted into the receiving holes. Which can be unlocked and locked with the slide of a lever. Anti-theft is also one of his goals and he can accommodate any concern you may address.

I just got the pictures scanned of my bumper. It looks great... I hope this persuades people to buy his products, because they are just GREAT!...

Here is just a street shot along with the one below it. The main shape of the bumper can be seen with the winch plate on. When its taken off it looks like the above pic of the Bronco. The OEM turn signals were a PITA to put in, most of the work was done by hand there, piece by piece. The Ramsey Winch sits high, and the Bumper actually supports the frame with braces as to not move the frame or bumper to any degree.

After my first test run with the winch, I found that the setup was ideal for what i needed. Something up out of the water and mud, and the bumper actually increased my approach angle significantly. The two D-Rings that sit on either side act as tow hooks for any strap. They are I want to say 1" thick and sit back about oh 6" or so into the bumper. The bumper it self weighs in right under 100lbs. The winch and the Plate add another 100, but i only have it on there when wheeling. Many thanks to Mike Pickel for his extraordinary work on this bumper!!

Winch in action!

All the holes that were created matched up perfectly with all the holes on the frame and cross members. No welding on the frame was necessary which is always a plus!

If you are interested and would like further information. Contact me at:
MudToy@mail.com

With the Subject: (**BUMPER**)

Site hosted by Angelfire.com: Build your free website today!