|
Here is a view of the pitot from below. Now I can rivet the nose skin closed again.
November 30, 2007
|
 |
Nose skin riveted closed again. I accidentally enlarged one hole when I was drilling out the A4 rivet and had to drill it bigger and go to an A5 rivet.
December 3, 2007
|
|
Fuel tanks and sensors are basically the same as those in the right wing, so installation was easy.
|
|
Here is a view of the auxiliary fuel tank bay. Cork strips have been installed and a hole for the fuel drain cock has been cut. 3 cork strips have also been attached longitudinally to the bottom of each tank to support the floor of the tank when it has fuel in it.
December 10, 2007
|
|
Strobe transformer has been mounted to the spar using 4 AN3 bolts. Wiring has been wrapped in plastic spiral wrap and routed under the ribs through the holes at the spar. Each hole was then flooded with silicon adhesive (the white stuff) to keep wire from moving.
December 15, 2007
|
|
Fuel tanks and associated wiring and plumbing are complete in this picture.
December 30, 2007
|
