MECER CORPORATION

B363C

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Linear Bus
Wiring Type   AUI Transceiver via DB-15 port

              RG-58A/U 50ohm coaxial
Boot ROM      Available

[Image]

               BASE I/O ADDRESS SELECTION

          Address                       JP2

            300h             Pins 1 & 2, 3 & 4 closed

            320h                 Pins 1 & 2 closed

            340h                 Pins 3 & 4 closed

            360h                     all open

                            INTERRUPT SELECTION

                 IRQ                                  JP1

  »                 3                         Pins 15 & 16 closed

                   2/9                        Pins 17 & 18 closed

                    4                         Pins 13 & 14 closed

                    5                         Pins 11 & 12 closed

                    6                          Pins 9 & 10 closed

                    7                          Pins 7 & 8 closed

                    10                         Pins 5 & 6 closed

                    11                         Pins 3 & 4 closed

                    12                         Pins 1 & 2 closed

         BOOT ROM CONFIGURATION

      Setting        JP3 (pins 7 & 8)

      Disabled             Open

      Enabled             Closed

                                ROM ADDRESS

      Address         JP3 (pins 1 &     JP3 (pins 3 &    JP3 (pins 5 & 6)
                           2)                4)

      C0000h             Closed            Closed             Closed

      C4000h              Open             Closed             Closed

      C8000h             Closed             Open              Closed

      CC000h              Open              Open              Closed

      D0000h             Closed            Closed              Open

      D4000h              Open             Closed              Open

      D8000h             Closed             Open               Open

      DC000h              Open              Open               Open

  AT BUS WAIT STATE CONFIGURATION

     Setting             JP4

  0 wait states         Closed

   1 wait state          Open

[Image]

                         DIAGNOSTIC LED(S)

    LED        Color      Status               Condition

    LED1       Green        On                    N/A

    LED1       Green       Off                    N/A

    LED2        Red         On          Data is being received

    LED2        Red        Off        Data is not being received

    LED3      Yellow        On         Data is being transmitted

    LED3      Yellow       Off       Data is not being transmitted