TRANSITION ENGINEERING, INC.

E-TBT-CHB-2012-M/E-TBT-CHB-2012-S

NIC Type:      Ethernet
Transfer Rate: 10Mbps
Data Bus:      16-bit ISA
Topology:      Star
Wiring Type    AUI transceiver via 50-pin port
Boot ROM       Not available

[Image]

                            INTERRUPT SELECTION

                 Setting                                 J1

  »       IRQ is software configured             Pins 2 & 3 closed

                     IRQ5                        Pins 1 & 2 closed

                               CARD NUMBER

   Card Number        SW1/1         SW1/2         SW1/3         SW1/4

  »       #0           On             On            On            On

          #1           On             On            On           Off

          #2           On             On           Off            On

          #3           On             On           Off           Off

          #4           On            Off            On            On

          #5           On            Off            On           Off

          #6           On            Off           Off            On

          #7           On            Off           Off           Off

       Note (1):SW1 is not installed on the HubServer card. The default
       setting for the HubServer card is #0.

       Note (2):The default setting for Expansion Hub cards is #1. If no
       HubServer card is used, the first Expansion Hub card should be set
       to #0. All daisy-chained Expansion Hub cards must be sequentially
       numbered starting at #1.

                                CONNECTORS

                Purpose                              Location

  Expansion card daisy-chain connector                 CN6

  Expansion card daisy-chain connector                 CN7

  Note (1):The first card of a cluster, usually the HubServer card, must
  have a termination plug installed on CN7.

  Note (2):The last card of a cluster must have a termination plug
  installed on CN6.