LANCAST

16-BIT 10BASE-T BOARD

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                                 BOOT ROM

                 Setting                                W1

  »               Disabled                             Open

                   Enabled                            Closed

                        BOOT ROM & I/O BASE ADDRESS

   Boot ROM Address      I/O Address           W2                W3

  »       C8000h          300 - 31Fh         Closed            Closed

          CC000h          320 - 33Fh          Open             Closed

          D0000h          340 - 35Fh         Closed             Open

          D4000h          360 - 37Fh          Open              Open

                                WAIT STATE

                Setting                                 W4

  »             0 wait states                          Open

                1 wait state                          Closed

                                INTERRUPT REQUEST

   IRQ       W5       W6       W7       W8      W11      W12      W13      W14

      2/9   Open     Open     Open    Closed   Open     Open     Open     Open

  »   3    Closed    Open     Open     Open    Open     Open     Open     Open

      4     Open    Closed    Open     Open    Open     Open     Open     Open

      5     Open     Open    Closed    Open    Open     Open     Open     Open

      10    Open     Open     Open     Open    Closed   Open     Open     Open

      11    Open     Open     Open     Open    Open     Closed   Open     Open

      12    Open     Open     Open     Open    Open     Open     Closed   Open

      15    Open     Open     Open     Open    Open     Open     Open     Closed

                                CABLE TYPE

                   Type                                  W9

  »         Unshielded twisted pair               Pins 1 & 2 closed

        AUI transceiver via DB-15 port            Pins 2 & 3 closed

                            LINK INTEGRITY TEST

                Setting                                 W10

  »                Enabled                       Pins 1 & 2 closed

                  Disabled                       Pins 2 & 3 closed

  Note:The link integrity test is only valid when the cable type is
  unshielded twisted pair.

                             DIAGNOSTIC LED(S)

    LED        Color        Status                 Condition

   LED1        Yellow      Blinking        Data is being transmitted

   LED1        Yellow         On         Data is not being transmitted

   LED2         Red        Blinking          Data is being received

   LED2         Red           On           Data is not being received

   LED3        Green          On       Twisted pair network connection is
                                                      good

   LED3        Green         Off       Twisted pair network connection is
                                                     broken

   LED4         Red           On         Twisted pair receive wires are
                                           reversed and corrected for

   LED4         Red          Off                Normal operation

  Note:If the link integrity test is disabled, LED3 will remain off.