PURE DATA, LTD.

PDI8023-16CAT

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star

              Linear bus
Wiring Type   Unshielded twisted pair

              RG58A/U 50ohm coaxial

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                       SOFTWARE CONFIGURATION RESET

                 Setting                                 E1

  »            Normal operation                  Pins 2 & 3 closed

                     Reset                       Pins 1 & 2 closed

  Note:Many of the options are configured using the setup utility
  provided with the card. To reset those configurations to the factory
  defaults, move E1 to the Reset position (pins 1 & 2 closed) and apply
  power for a few seconds. Always make sure that you turn off the power
  to the computer before you change any jumpers.

                              CARD I/D NUMBER

    Number           E2A            E2B           E2C            E2D

  »      1          Open           Open           Open          Closed

         2          Open           Open          Closed          Open

         3          Open          Closed          Open           Open

         4         Closed          Open           Open           Open

  Note:Up to four cards can be installed into a system at the same time.

  If more than one card is installed each one must have a seperate card
  I/D number.

                            LINK INTEGRITY TEST

                Setting                                 E3

  »                Enabled                       Pins 1 & 2 closed

                  Disabled                       Pins 2 & 3 closed

  Note:The link integrity test is only valid when the cable type is
  unshielded twisted pair.

                                CABLE TYPE

         Type              E5A       E5B        E5C          Isolation
                                                            Transformer
                                                             Location

  »    RG58A/U 50ohm      Open      Closed     Open             T3
          coaxial

         Unshielded       Open       Open     Closed           N/A
       twisted pair

      AUI transceiver    Closed      Open      Open             T2
      via DB-15 port

  Note:If you leave E5B closed you can select the cable type through the
  software setup utility included with the card. However, you must still
  move the Isolation transformer to the appropriate socket.

                              SEGMENT LENGTH

             Maximum Length                            JP7

  »              185 meters                     Pins 2 & 3 closed

                 300 meters                     Pins 1 & 2 closed

       Note:Segment length is the total length of cable between the two
       farthest cards on the segment. Each card on the segment must have
       this option set the same.

[Image]

                             DIAGNOSTIC LED(S)

     LED         Color         Status                Condition

    LED1         Green           On         Data is being transmitted or
                                                      received

    LED1         Green          Off         Data is not being transmitted
                                                    or received

    LED2          Red            On        Card is being accessed by host
                                                      computer

    LED2          Red           Off         Card is not being accessed by
                                                   host computer