KODIAK TECHNOLOGY, INC.

KODIAK~16 10BT

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Linear bus
Wiring Type   Unshielded twisted pair
Boot ROM      Available

[Image]

                            COMPATIBILITY MODE

                 Setting                                JP1

  »                Disabled                            Open

                   Enabled                            Closed

       Note:On some systems the data bus timing is not truly IBM PC/AT
       compatible. If the card does not initialize or you receive an
       "Error Reading Address PROM" message, compatibility mode should be
       enabled (JP1 closed).

                             INTERRUPT REQUEST

     IRQ       JP2A     JP2B     JP2C     JP2D    JP2E     JP2F     JP2G

       2/9     Open     Open     Open     Open    Open     Closed   Open

  »     3      Open     Open     Open     Open    Closed   Open     Open

        5      Open     Open     Open    Closed   Open     Open     Open

       10      Open     Open     Open     Open    Open     Open     Closed

       11     Closed    Open     Open     Open    Open     Open     Open

       12      Open    Closed    Open     Open    Open     Open     Open

       15      Open     Open    Closed    Open    Open     Open     Open

      Polled   Open     Open     Open     Open    Open     Open     Open
       I/O

                             I/O BASE ADDRESS

       Address             JP2H             JP2I               JP2J

           200h            Open            Closed             Closed

           210h            Open            Closed              Open

  »        300h            Open             Open              Closed

           310h            Open             Open               Open

                             BOOT ROM ADDRESS

         Address                   JP3A                     JP3B

         C8000h                   Closed                   Closed

         CC000h                   Closed                    Open

         D8000h                    Open                    Closed

         DC000h                    Open                     Open

       Note:In earlier versions of this card there is no socket for a
       boot ROM. If you have one of these earlier socketless versions and
       you purchased it less than five years ago, you may return it to
       the manufacturer for an updated version. You can also solder in a
       socket for a boot ROM but you will void the warranty.

                                 BOOT ROM

                 Setting                               JP3C

  »               Disabled                             Open

                   Enabled                            Closed

                               CABLE LENGTH

                 Length                                 JP5

  »             < 100 Meters                           Open

                > 100 Meters                          Closed

  Note:The hub must support cable lengths of greater than 100 meters if
  this option is used.

                      TRANSMIT/RECEIVE WIRE POLARITY

                Setting                         SW1 (SW1/1 & SW1/2)

  »                Normal                               On

                  Reversed                              Off

       Note:If the transmit/receive wires are reversed, they can be
       corrected for by setting this option to reversed. On some earlier
       versions of this card there are two switches. On these older cards
       each switch should be set the same.

                             DIAGNOSTIC LED(S)

         LED1                 Hub LED                  Condition

          On                    On            Network connection is good

         Off                    Off           Tx/Rx polarity crossover at
                                                        adapter

  Note:The Hub LED is located on the Hub not the NIC.

  If a crossover condition exists, this can be corrected for by using
  switch SW1.