ADVANCED INTERLINK CORPORATION

AICETHER-16/10BT

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star
Wiring Type   Unshielded twisted pair
Boot ROM      Available

[Image]

                             INTERRUPT REQUEST

   IRQ      JP2A     JP2B      JP2C     JP2D     JP2E     JP2F     JP2G

      2/9   Open     Open      Open     Open     Open    Closed    Open

  »   3     Open     Open      Open     Open    Closed    Open     Open

      5     Open     Open      Open    Closed    Open     Open     Open

      10    Open     Open      Open     Open     Open     Open    Closed

      11    Closed   Open      Open     Open     Open     Open     Open

      12    Open     Closed    Open     Open     Open     Open     Open

      15    Open     Open     Closed    Open     Open     Open     Open

                             I/O BASE ADDRESS

          Address                   JP2I                    JP2J

             200h                  Closed                  Closed

             210h                   Open                   Closed

  »          300h                  Closed                   Open

             310h                   Open                    Open

        BOOT ROM ADDRESS

  Address     JP3A      JP3B

  C8000h     Closed    Closed

  CC000h     Closed     Open

  D8000h      Open     Closed

  DC000h      Open      Open

                                 BOOT ROM

                 Setting                               JP3C

  »               Disabled                             Open

                   Enabled                            Closed

  Note:Location of the boot ROM may vary on different revisions of this
  card.

                          SEGMENT LENGTH

     Maximum Segment Length                     JP5

           100 meters                         Closed

           300 meters                          Open

  Note:Segment length is the distance from the card to the hub.

                            COMPATIBILITY MODE

                 Setting                               JP10

  »               Disabled                             Open

                   Enabled                            Closed

  Note:Compatibility mode is provided to compensate for timing
  differences between the card and host computer.

                              TX/RX CROSSOVER

                   Mode                                  SW1

  »                  Normal                              On

                   Crossover                             Off

       Note:If the diagnostic LEDs indicate that the transmit & receive
       wires are reversed (LED1 Off, Hub LED Off) you can correct the
       problem by using the crossover option.

  FACTORY CONFIGURED SETTINGS

     Jumper         Setting

      JP2H            Open

                             DIAGNOSTIC LED(S)

       LED1            Hub LED                    Condition

        On               On               Network connection is good

       Off               Off          Transmit/Receive wires reversed at
                                                     card

        On               Off           Receive polarity reversed at hub

       Off               On           Receive polarity reversed at card

  Note:The Hub LED is located on the hub, not on the card.