DANPEX CORPORATION

EN-2000B

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Linear Bus
Wiring Type   RG58A/U 50ohm coaxial

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                               ACTIVITY LED

               Setting                                 JP1

               Enabled                               Closed

               Disabled                               Open

  Note:If the network hub has an activity LED for each line, setting this
  option to enabled will allow the hub LED to

                                WAIT STATE

           Setting                    JP5                    JP6

  »       0 wait states               Open                   Open

          1 wait state                Open                  Closed

          2 wait states              Closed                  Open

  Note:This option is ignored if the card is installed in an IBM PC,
  PC/XT, or PS/2 Model 30.

                                CABLE TYPE

                   Type                              JP7A - JP7F

  »          RG58A/U 50ohm coaxial                     Closed

        AUI transceiver via DB-15 port                  Open

                             INTERRUPT REQUEST

   IRQ      JP8A     JP8B      JP8C     JP8D     JP8E     JP8F     JP8G

      2/9   Closed   Open      Open     Open     Open     Open     Open

  »   3     Open     Closed    Open     Open     Open     Open     Open

      4     Open     Open     Closed    Open     Open     Open     Open

      5     Open     Open      Open    Closed    Open     Open     Open

      10    Open     Open      Open     Open    Closed    Open     Open

      12    Open     Open      Open     Open     Open    Closed    Open

      15    Open     Open      Open     Open     Open     Open    Closed

                                 BOOT ROM

                 Setting                               JP9A

  »               Disabled                             Open

                   Enabled                            Closed

             BOOT ROM ADDRESS

  Address     JP9B       JP9C      JP9D

  C8000h     Closed      Open     Closed

  CC000h      Open       Open     Closed

  D0000h     Closed     Closed     Open

  D4000h      Open      Closed     Open

                             I/O BASE ADDRESS

          Address                   JP9E                    JP9F

  »          300h                  Closed                  Closed

             320h                   Open                   Closed

             340h                  Closed                   Open

             360h                   Open                    Open

                            ONBOARD TERMINATOR

                Setting                                JP10

  »               Disabled                       Pins 1 & 2 closed

                   Enabled                       Pins 2 & 3 closed

       Note:If the card is on either side of the network segment, the
       onboard terminator may be enabled instead of using a T-connector
       and an external terminator.