ACCTON TECHNOLOGY CORPORATION

ETHERCOMBO-16 (EN1640)

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star

              Linear Bus
Wiring Type   Unshielded twisted pair

              RG58A/U 50ohm coaxial

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                       INITIAL STATE CONFIGURATION

                  Mode                                  JP1

  »        Initial state disabled 1                    Open

           Initial state enabled 2                    Closed

      Note 1 Adapter uses default configuration settings, or user
      selected settings through software.
      2 Adapter is forced into an INITIAL STATE, where adapter mode is
      NE1000, I/O address is 280h, IRQ is

                                CABLE TYPE

                  Type                                 JP2

         RG-58A/U 50ohm coaxial                 Pins 1 & 2 Closed

     AUI transceiver via DB-15 port             Pins 2 & 3 Closed

  Note:Twisted pair wire is selected through the configuration software
  that comes with the card.

                             DIAGNOSTIC LED(S)

     LED         Color         Status                 Condition

    LED1         Green           On              Twisted pair network
                                                 connection is good

    LED1         Green           Off             Twisted pair network
                                                connection is broken

  Note:LED1 indications are only valid when the cable type is twisted
  pair wire.