BUSLOGIC, INC. BT-560A NIC Type Ethernet Transfer Rate 10Mbps Data Bus 16-bit ISA Topology Linear Bus Wiring Type RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port Boot ROM Available [Image] I/O CHANNEL READY Setting JP1 » Disabled Pins 2 & 3 Closed Enable Pins 1 & 2 Closed Note:In some cases memory may require a lengthened transfer cycle. In these cases, the BT-560A must wait for a Host I/O READY signal (set to Host I/O Channel Ready Signal to Enabled). CARD FUNCTION Setting SW1/1 » Enabled On Disabled Off INTERRUPT REQUEST IRQ SW1/2 SW1/3 SW1/4 2/9 Off Off On 10 On Off On 11 Off On On » 15 On On On DMA CHANNEL Channel SW1/5 SW1/6 Disabled Off Off DMA5 On Off DMA6 Off On » DMA7 On On DATA BUS TRANSFER RATE Setting SW1/8 SW1/9 » 5MBps On On 6.7MBps On Off 8MBps Off On 10MBps Off Off Note:This setting specifies the rate at which the card transfers data (in Megabytes per second) on the data bus when acting as a bus master MEMORY STROBE-TIMING Setting SW1/10 » 150ns On 100ns Off Note: This switch selects the amount of time between the PC/AT's memory-write or memory-read command strobes. BOOT ROM ADDRESS Address Boot ROM SW2/1 SW2/2 SW2/3 SW2/4 C0000h 8K or Off Off Off Off 16K C2000h 8K On Off Off Off C4000h 8K or Off On Off Off 16K C6000h 8K On On Off Off C8000h 8K or Off Off On Off 16K CA000h 8K On Off On Off CC000h 8K or Off On On Off 16K CD000h 8K On On On Off D0000h 8K or Off Off Off On 16K D2000h 8K On Off Off On D4000h 8K or Off On Off On 16K D6000h 8K On On Off On D8000h 8K or Off Off On On 16K DA000h 8K On Off On On DC000h 8K or Off On On On 16K » DE000h 8K On On On On BOOT ROM SIZE Size SW2/5 SW2/6 » Disabled On On 8K size Off On 16K size On Off CABLE TYPE Type SW2/7 » RG-58A/U 50ohm coaxial On AUI transceiver via DB-15 port Off I/O BASE ADDRESS Address SW2/8 SW2/9 SW2/10 100h Off Off Off 120h On Off Off 140h Off On Off 160h On On Off 300h Off Off On 320h On Off On » 340h On On On