Site hosted by Angelfire.com: Build your free website today!
  Tinting

01/16/05

Home
Electric Superchargers
Tinting
Dash
Pedals
Button Starter
Custom Made Bodykits
Clear Turn Signals
Race Seats
Body Kit
Steering_Wheel
Interior Panels
Buy a bodykit

 

Push Button Starter Install
 
Description

The Honda S2000 and BMW Z8 Push button starter is very easy to install on just about every vehicle. It helps if you have some knowledge of your cars electrical system but these instructions will give you an idea how the install is if you dont. You can choose from a large variety of starter buttons to suite your particular interest.

These instructions outline the general process of installing a push button ignition on just about any Import or Domestic vehicle.
Installation Instructions
 

Please be advised that while these instructions can be applied to most import and domestic cars they may not be compatible with all car models.

 
Disconnect the Negative Terminal of the Battery

On the rear of the existing ignition switch (on your steering column) you identify the switched 12v feed (usually white) and the starter solenoid cable (usually white/red) and solder on extra leads to the two solder connectors. Route these two wires to the rear of the push button starter switch so that they are in parallel (electrically) with the existing connections.

The three circuit diagrams below show the standard installation, dual installation (both key and push button will crank the engine) and isolated installation (in which the ignition key will not crank the engine).

Once the installation has been completed, reconnect the negative terminal of the battery.

To operate the new starter button, insert the ignition key and turn it to the IGN position and then press the starter button.

 
 
Push Button Starter fitted center console.
 
 
 
 
The finished push button can be placed just about anywhere you choose inside your car. Often people mount the button close to the original starter location or somewhere on the center console.
 
Installation Instructions (Aircraft Style Buttons)
 
Disconnect the Negative Terminal of the Battery
 

On the rear of the existing ignition switch (on your steering column) you identify the permanent 12v feed (usually brown) and cut into this about 2 inches from the ignition switch. Solder in an extension cable to your new aircraft style switch from both ends of the newly cut cable.

Once the installation has been completed, reconnect the negative terminal of the battery.

 
Typical 'Aircraft Type' Switch.
 
To start the engine, you will then need to turn on the ignition with the key thus releasing the steering column lock, throw the aircraft style switch to complete the ignition circuit and press the starter button to crank the engine. Gentlemen, start your engines .....

 

Home | Electric Superchargers | Tinting | Dash | Pedals | Button Starter | Custom Made Bodykits | Clear Turn Signals | Race Seats | Body Kit | Steering_Wheel | Interior Panels | Buy a bodykit

This site was last updated 01/16/05