ChanServ Commands

Set

XOP

-
-ChanServ- Syntax: SET channel XOP {ON | OFF}
-
-ChanServ-
-
-ChanServ- Enables or disables the xOP lists system for a channel.
-
-ChanServ- When XOP is set, you have to use the AOP/SOP/VOP
-
-ChanServ- commands in order to give channel privileges to
-
-ChanServ- users, else you have to use the ACCESS command.
-
-ChanServ-
-
-ChanServ- Technical Note: when you switch from access list to xOP
-
-ChanServ- lists system, your level definitions and user levels will be
-
-ChanServ- changed, so you won't find the same values if you
-
-ChanServ- switch back to access system!
-
-ChanServ-
-
-ChanServ- You should also check that your users are in the good xOP
-
-ChanServ- list after the switch from access to xOP lists, because the
-
-ChanServ- guess is not always perfect... in fact, it is not recommended
-
-ChanServ- to use the xOP lists if you changed level definitions with
-
-ChanServ- the LEVELS command.
-
-ChanServ-
-
-ChanServ- Switching from xOP lists system to access list system
-
-ChanServ- causes no problem though.