IndexThe Unpacked KitRibbon Lining End-Piece Set Guitar Top Top Bracing Guitar Back Back Bracing Attaching the Back Attaching the Top Edge Bindings Fitting the Neck Truss Rod Fingerboard Fretting Fitting the Nut Grain Filling Lacquering Attaching the Neck Attaching the Bridge Saddle and Nut It's Done! |
The simplest way to clamp on the strips while the glue dries is to use masking tape. Basically, I'd rip off many strips of tape in advance, coat about an 8" section of the channel with glue, and then press the binding strip into place and tape it down. Once I made it all around, I needed to cut the strip to just the right length so that the seam would be as invisible as possible.
Once the glue is dry, the masking tape is removed. The top is done in the same way, except that the top binding is done with two strips of plastic.
|
| Previous Page | Return to Home Page | Next Page |
