Its not the best looking pipe, but it works really well
heres What you'll need:
A Soda Can
3 inches of 3/4 inch PVC pie
A 3/4 PVC elbow
A 3/4 PVC end cap (not threaded)
Tape
First get a needle or a paperclip, (anything that can poke small holes) and poke about 7-10 hole in a small area of the soda can.
Then Cut out the area you poked the holes in * leave about half an inch around the holes* (total diameter should be two inchs or more) its better to have
more than you need and jsut trim it than to start over. then put the pice of can into the elbow, this will be the screen for the bowl. tear of verry small pices
of tape and put around the mouth or the bowl. this will hold in the screen. be sure not to put the tape too far into the bowl. nextput the 3 inch pice of PVE pipe into the other end of the elbow, it should look like a pipe now.
Cover the open end of the pipe with tape and punch a hole in the center of the tape. ( this prevents and ashes that fall through the screen to get in your mouth cuz they stick on the tape)
drill a hole in the top of the end cap ( the top would be the round part )( the hole makes a vacume so you get more smoke ) then put it on the pipe it should look like the picture above. the last step is to drill a "carb" look at the picture above see the little black dont on the elbow? drill a hole right there * make sure is above or behind the place where
the 3 inch PVC pipe was put in, but below the screen* ( the carb is also to make more smoke go into the pipe )
To use the pipe just put your weed in the bowl and hold the pipe by the elbow then put your lighter ( a zippo works best ) next to the weed suck hard and put your finger on the carb, then take it off, then put it on......this mixes air and smoke in the pipe and you get higher......
