 |
Minimum
Requirements for Hyjet® Bidet Installation
Note: The Hyjet® Bidet fits most standard
size toilets with a water closet and bowl
assembly.
- The toilet hook-up or main water supply
hose (connects angle valve to the water
closet) should be a flexible hose type,
and not the rigid metal type. If rigid
metal, it must be replaced with a flexible
hose.
- The surfaces of the toilet bowl and
the toilet seat cover, where the bidet
is to be installed, must be flat surfaces.
- The maximum distance between the toilet
seat screw holes and the nearest inner
rim of the toilet bowl should not be more
than 3 inches. This is standard in most
toilets.
IMPORTANT - Please
Read Before Installing
- This product uses o-rings and gaskets
that have been taped in place to prevent
loss prior to installation. Please remove
tape and make sure the appropriate o-rings
and gaskets are put it their proper place
upon installation.
- If your toilet plumbing and fittings
are old and worn-out, you may need to
either replace them with new ones or use
teflon tape to ensure proper installation.
- It is recommended that all parts are
hand-tightened only.
--------------------------------------------------------------------------------
Step 1: Make sure you have all the parts of the Hyjet® Bidet
System. Each set comes with the following parts:
Bidet Body with two adjustable circular plates, nozzle housing and bidet valve (A)
Bidet Hose (B)
T-body connector (C)
Nozzles: Shower Spray and Jet Spray (D)
Step 2: Make sure that one big rubber o-ring (E) is inserted in
the nozzle housing before you insert it into the bidet body.
Step 3: Make sure that the second big o-ring (G) is inserted
correctly on the opposite side of the first big o-ring (E). The small
rubber o-ring (F) should be inserted correctly in the nozzle housing.
| | |
