Site hosted by Angelfire.com: Build your free website today!
  Stop Arresting Smokers
Home ------- G-Spot ------- Pictures Links The Vault
SHIT YOU NEED:
1. ephedrine or (p)ephedrine
2. iodine krystals
3. red phosphorus
4. condencer (hose running into water in an air tight/taped bottle)
5. lye (red devil lye drain opener - it's pure)
6. ether
7. hydrochloric acid/muriatic acid (hcl)
8. burner/heet/fire... whatever
9. flask/jar

EPHEDRINE:
(from ephedra plant)
The dried and pulverized plant materials (1.0 g) were extracted with 70ml 0.5 M H2SO4 (sulfuric acid) for 12 h. The filtered exstract was abjusted to pH 11-13 by addition of 6 M NaOH (lye). 16 g NaCL (rock salt) was added in the exstract to remove the salts and exstracted with 100 ml diethyl ether three times. The diethyl ether phase was evaporated to dryness.

(from pills)

IODINE KRYSTAL:
Take one 20 oz, plastic Coke Bottle and pour 4 Bottles 2% tincture into it. Add Hydrogen Peroxide to this. Use only 1/2 a bottle of Hydrogen peroxide. After this, take the cap from the gallon jug that the Muriatic acid. Fill it with the acid and pour it in. (Place in a freezer for at least 30 minutes). Get a clean mason jar, on top of this place 1 coffee filter and pour the contents of the Iodine + Muriatic Acid + Hydrogen Peroxide mixture into the filter (do it slowly don't over pour) Once you get though with the filtering, there will be a black substance on the filter. (These are iodine crystals) Dry them by wrapping in more coffee filters till you get a pretty good thick pile around the original filter, place on ground and step on it to get the rest of the liquids off. keep in dark, dry, kool place.

-----------------------OR---THIS ONE I KNOW WORKS--------------------------------

30% HYDROCHLORIC ACID - "MURIATIC ACID" IN HARDWARE STORES
-BLEACH
-TINCTURE OF IODINE
-COFFEE FILTERS
-MISC. GLASSWARE

1. FIND SOME TINCTURE OF IODINE. IT COMES IN SMALL BOTTLES AND IS SOMEWHAT EXPENSIVE. YOU MAY HAVE TO SEARCH HARD BECAUSE ITS SOMEWHAT OBSOLETE NOW. DO NOT USE POVIDONE IODINE. POVIDONE IODINE HAS A CHEMICAL ADDED TO PREVENT STINGING WHEN USED AS AN ANTISEPTIC. FOR WHATEVER REASON, POVIDONE IODINE IS CHEAPER AND AVAILABLE IN LARGER QUANTITIES, BUT I'M TOLD IT WILL NOT WORK.

2. POUR A FEW BOTTLES INTO A FLASK. USE MORE THAN ONE BOTTLE AT A TIME. THE REASON IS THAT YOU'LL LOSE A FRACTION OF THE IODINE IN VARIOUS WAYS, AND IF YOU USE A SINGLE BOTTLE THERE WILL BE TOO LITTLE IODINE LEFT TO RETRIEVE SUCCESSFULLY.

3. ADD AN EQUAL VOLUME OF WATER TO THE IODINE. THEN ADD ABOUT ~5ML OF HYDROCHLORIC ACID PER BOTTLE OF IODINE. STIR. THEN ADD ~10ML OF BLEACH PER BOTTLE OF IODINE. STIR. BEWARE FUMES. YOU SHOULD SEE THIS: THE ACID HELPS CONVERT THE IODINE SALTS (KI, NaI) TO THE DESIRED FORM. NOTE, EXCESS REAGENTS IS USUALLY NOT A PROBLEM.

4. PREPARE TO FILTER BY PUTTING TWO COFFEE FILTERS OVER THE MOUTH OF A BEAKER. BE SURE TO USE TWO OR MORE FILTERS. THE ACIDS WILL ATTACK THE PAPER, AND ALONG WITH MOISTURE, CAN BREAK THE FILTER.

5. DILUTE AND FILTER THE SOLUTION. YOU NOW HAVE I2.

RED PHOSPHORUS:

ETHER:
spray starting fluid into jar or bag and add the same amount of water. the top layer is ether. the best type of fluid is prestone cold weather high ether.

HCL GAS:

THE COOK:
1. add 1g ephedrine to about same vol water, then 1g iodine krystal, then 1/3g red phosphorus (1:1:1/3)
2. put on the condencer (other end of hose on flask) right away! right after the phosphorus is added! and tape it air tight. put on burner, boil till it don't boil any more
3. let kool then add some hot water to unstick it from the jar/flask. shake it.. duh.
4. base with lye. it will stay cloudy. and make sure it's kool for the next step cuz it heets up.
5. add ether. shake it hard! you wanna get all the tweek in the ether. remove and save top layer. get rid of the lower layer.
6. gas with hcl. filter with filter paper. dry. enjoy.