CAP will engage
Fighters
parts list
This is for one model
|
part no |
material |
dimensions |
no. off |
|
1 |
0.4mm thick plastic card | 5mm x 6mm |
1 |
|
2 |
0.75mm thick plastic card | 5 mm x 2mm |
1 |
|
3 |
0.75mm thick plastic card | 2.5mm x 1mm |
1 |
|
4 |
0.4mm thick plastic card | 3mm x 4.5mm |
2 |
|
5 |
0.5mm plastic rod | 2mm long |
1 |
|
6 |
0.5mm plastic rod | 3.5mm long |
2 |
|
7 |
2mm rod | 2mm long |
1 |
Assembly
|
|
|
|
|
 |
| FIG 1 | FIG 2 | FIG 3 | FIG 4 | FIG 5 |
 |
|
 |
 |
 |
| FIG 6 | FIG 7 | FIG 8 | FIG 9 | FIG 10 |
Stage 1 Glue part 2 (the fuselage) to part 1 (the wing) centrally with the front edge level with front of wing.
Stage 2 Glue part 3 (spine) centrally on fuselage at rear
Stage 3 Cut slope on front of both parts 4 (side fins)
Glue one part 4 (side fin) to each side of part 2 (the fuselage) at rear.
Leave to dry fully
Stage 4 Cut forward edge of part 1 (wings) to give a swept back look.
Make cut approximately half way back along part 2 ( the fuselage)
Trim away the waste in front of this line to match the fuselage shape.
Stage 5 Cut slope on front of part 2 (the fuselage)
Stage 6 Glue part 5 (cockpit) to centre of fuselage in front of spine
Stage 6 Glue parts 6 (the missile launchers) to each side of part 2 ( the fuselage) at rear
Stage 8 Glue part 7 (engines) to assembly at rear of wing aligning the top with the top of the spine
Leave till completely dry
Stage 9 Drill 0.5mm hole in underside of wing and insert and glue a length of 0.5mm brass rod
Stage 10 Cut a 2mm thick square of plastic card and drill to receive the required number of ordnance
Glue stems in holes . Leave to dry.
All that is now required is to paint the completed ordnance stand. Here are the stands described above painted and ready for action.
|
 |
 |
