I trimmed some of the wire cover back to give me some more wire to work with. For the blinker part there should be a wire cover type thing coming off the marker one where it splits into 2. The one going to the turn signal lights I cut so I could take the green wire out of that and put into the other part of the light socket. Be careful and make sure you get plenty of wire for the turn signal part or you will have a hard time getting the socket to stay. The easiest way I figured out wish was what was have the wires barley in there not clamped down or anything and turn the parking lights on. wich ever one is brighter is the signal part of the light switch. Then all you have to do is clamp it down.

After I got one wired and figured out how to wire the thing I used the other light socket as my pattern to cut both holes in both marker lights. The way I did it is I enlarged the original hole so it would look more stock from the outside and I didn’t feel like dragging the drill out Lol. First thing I did was cut the lip off of it.

After doing this I got my handy dandy dremel tool out and used it to enlarge the hole big enough for the socket to go into. This has to be a pretty tight fit or it will fall out. I learned this the hard way and I am using RTV gasket maker to hold the lights in. Use a pen and sit the socket on the housing and draw the farthest you can cut. Make sure it fits in there pretty good. Here is the one with the new hole and the one with the standard one next to each other. Page 4