upgrades
REGULATORS
| Air America Vigilante | Palmer Pursuit Shop Stabilizer |
|
|
|
| The Air America Vigilante has been on the market for a long time. It's a proven reg and is top of it's class. This reg offers the highest flow rate of any reg on the market and offers great shot to shot consistency. Stock it will only only go down as low as 300psi, so for operation of a Bushmaster 2000 or Defiant you will need to purchase the low pressure spring which is easily installed. This is not a reg designed for Co2, although I can confirm it will work well as the 2nd reg in a dual reg Co2 setup. You will need to purchase an ASA adapter to mount any after market regs on your Bushmaster or Defiant. | Palmer's Stabilizer reg has also been around for a long time and is another solid performer. It's 2nd in flow rate only to the Vigilante. It's shot to shot consistency is also great just like the Vig. Out of the box this reg will operate between 100 and 1000psi so there is no need for a low pressure spring upgrade. The Stabilizer will also work well on Co2 or Nitro/Compressed. Use the Female Stabilizer as the 1st reg in a dual reg Co2 setup or use the Male Stabilizer as the primary reg in a pre-set Nitro/ Compressed setup. You will need to buy an ASA adapter to mount any after market regs on your BM or Defiant. |
|
|
| Sonic Low Pressure Regulator Kit | |
|
|
|
| The Sonic LPR is a replacement for your stock LPR. It's got a standard allen screw pressure adjustment wheel. The LPR should run at 90 psi for optimal efficiency and performance. The handy gauge that comes in the kit lets you dial in to 90psi exactly. This will make your gun cycle smoother, faster and those occasional leaks will stop happening. It even comes with a spring for precision. As an added bonus it's much thinner than the stock LPR and doesn't stick out as far off the front of your gun giving it a sleeker profile. | The newest in the low pressure regulator arena, the AKA Sidewinder. This reg was built to be high flow, low pressure right from the start AKA's gun. They weren't happy with anything out there so built their own. AKA says the reg is the highest flowing out there, only drops about 50psi per shot instead of 100-150psi like other cheaper regs and shoots right back up to the set pressure instead of creeping up. Although I can't give my official performance opinion yet, i will say they did 2 great design decisions. The swivel bottom is great, it turns 360 degrees and the bottom inlet is also great, gets the hoses out of the way. Watch my review area for my review of the Sidewinder and how it stacks up against the Vig and Stab. |
|
|
| Gladiator In-Line Regulator | Co2 Pin-Valve Regulator |
|
|
|
| MacDev's newest product is an inline regulator built for the Bushmaster/Defiant (although it will work with any marker). Designed from the ground up to be high flow and fast recharging. Pressure adjustment is on the side and the air inlet hole is on the bottom getting the hose out of the way. This reg will be available soon and we'll see how it stacks up against the Sidewinder and Vigilante. IT will sell for about $85 msrp. | This is a cool little add-on for your standard Co2 tank. You take your current pin valve out and replace it with this. It's an on-tank regulator to regulate your Co2 output pressure from 200 to 900 psi. It is also still compatible with anti-siphon tubes so you can keep yourself safe from liquid. You could use this instead of a female stabilizer and then run into the stock or after market on-gun regulator. |
|
|
| AA Massiah | ICD's Pre-Set Tank Regulator Upgrade Kit |
|
|
|
| This is Air America's newest regulator designed from the ground up for today's low pressure, high air demand electronic markers. It's about 1/2 the length of the industry standard Vigilante and is available in many different colors. 2 air inlet holes and velocity adjustment on the bottom, same as the Vigilante. Works at 0-500 psi out of the box and is higher flowing than it's older cousing, the vigilante, however at almost twice the cost. | This kit is for people who have guns with SN 2700 or less that want to run their gun on a preset tank. The 1st gen of regulators were designed for 500psi or less input. This regulator upgrade kit comes with a heavy duty spring and new endcap. This upgrade costs 10 bucks and will let you use a preset tank efficiently without damaging your gun. |
|
|
