The following tells how to make landmines
How to make a landmine by The Jolly Roger First, you need to get a pushbutton switch. Take the wires of it and connect one to a nine volt battery connector and the other to a solar igniter (used for launching model rockets). A very thin piece of stereo wire will usually do the trick if you are desperate, but I recommend the igniter. Connect the other wire of the nine-volt battery to one end of the switch. Connect a wire from the switch to the other lead on the solar igniter. switch-----------battery \ / \ / \ / \ / solar igniter | | | explosive Now connect the explosive (pipe bomb, m-80, CO2 bomb, etc.) to the igniter by attaching the fuse to the igniter (seal it with scotch tape). Now dig a hole; not too deep but enough to cover all of the materials. Think about what direction your enemy will be coming from and plant the switch, but leave the button visible (not TOO visible!). Plant the explosive about 3-5 feet away from the switch because there will be a delay in the explosion that depends on how short your wick is, and, if a homemade wick is being used, its burning speed. But if you get it right... and your enemy is close enough......... BBBBBBBOOOOOOOOOOOOOOOOOOOOOOOOMMMM! hahahaha
The following shows how to make a tennis ball bomb
Tennis Ball Bombs by The Jolly Roger Ingredients: - Strike anywhere matches - A tennis ball - A nice sharp knife - Duct tape Break a ton of matchheads off. Then cut a SMALL hole in the tennis ball. Stuff all of the matchheads into the ball, until you can't fit any more in. Then tape over it with duct tape. Make sure it is real nice and tight! Then, when you see a geek walking down the street, give it a good throw. He will have a blast!!
the following shows how to make pipe bombs
Pipe Hand Grenade by the Jolly Roger Hand Grenades can be made from a piece of iron pipe. The filler can be of plastic or granular military explosive, improvised explosive, or propellant from shotgun or small arms munition. Material Required: ----------------- Iron Pipe, threaded ends, 1-1/2" to 3" diameter, 3" to 8" long. Two (2) iron pipe caps Explosive or propellant Nonelectric blasting cap (Commercial or military) Fuse cord Hand Drill Pliers Procedure: --------- 1) Place blasting cap on one end of fuse cord and crimp with pliers. NOTE: To find out how long the fuse cord should be, check the time it takes a known length to burn. If 12 inches burns in 30 seconds, a 6 inch cord will ignite the grenade in 15 seconds. 2) Screw pipe cap to one end of the pipe. Place fuse cord with blasting cap into the opposite end so that the blasting cap is near the center of the pipe. NOTE: If plastic explosive is to be used, fill pipe BEFORE inserting blasting cap. Push a round stick into the center of the explosive to make a hole and then insert the blasting cap. 3) Pour explosive or propellant into pipe a little bit at a time. Tap the base of the pipe frequently to settle filler. 4) Drill a hole in the center of the unassembled pipe caplarge enough for the fuse cord to pass through. 5) Wipe pipe threads to remove any filler material. Slide the drilled pipe cap over the fuse and screw handtight onto the pipe. Ready to go!