[PROTEL EDA USERS]: Print/Preview crash system

[Rudolf Schaffer <info@asgalium.com>]

Hello,

May be a problem with P99SE...? and/or
a bad operation of my side?

After a correct design and manufacturing of
a rounded PCB with custom angles for
some of the components, i try this
morning to prepare an implementation
drawing for soldering process with Print/Preview.

I receive the following error(warning):

"This canvas does not allow drawing"

I select Ignore expecting to return in
the PCB session; the xxx_ti.pcb set
for the top components implementation
was totally off (gray screen) and at this
moment, the system go into power-down
without any intervention of my part!
Somebody has done a similary experience?

Many thanks in advance.

Regards.

PC: P2, 128Mb Win95 P99SE Sp5

Rudolf Schaffer

ASGALIUM UNITEC SA
Rue du Puits-Godet 8a
CH-2000 NEUCHATEL
tel +41 32 7240066  fax +41 32 7240078