Two vertical dashed lines indicate magnetically coupled coils or a ferrite rod antenna. There are three coils shown on the rod but only two of them are used. On the left a small coil is labeled small winding. The bottom, black leed, of this winding is connected to circuit common and earth ground. The top, white, is connected to an antenna. On the right a larger winding has it's yellow leed connected to common. The upper, green, leed connects to a variable cap. The other end of the cap goes to common. The green leed also goes to pin 1, grid, of the 6AU6 tube. The cathode, pin 7, goes through the parallel combination of a 150 k ohm resistor and a 100 peco farad cap to common. The cathode also goes through a 0.01 microfarad 200 v cap to the output terminal. A 4.7 meg ohm resistor connects from the output to common. The suppressor grid, pin 2, goes to common. The heater, pins 3 and 4 connect to a source of 6.3 volts. The plate, pin 5, and the screen grid, pin 6, connect to 150 volts DC. End verbal description.
go back.