VIEW2.JPG (51901 bytes)
VIEW1.JPG (56058 bytes)
WELDS.JPG (51607 bytes)

FLANGE WAS WELDED IN PLACE,  THEN TURNED ON A LATHE.
WELDS2.JPG (67760 bytes)

NEED I SAY MORE?
DRILLED.JPG (68997 bytes)

AND WHAT THE HECK HAPPENED HERE???  DID THE DRILL PRESS GET AWAY FROM HIM?
SNOUT.JPG (75680 bytes)

THIS SHOWS THAT AN INSERT WAS WELDED IN PLACE,  THEN TAPPED.  THE END OF THE SNOUT WAS THEN GROUND FLAT...  SORTA.  NOTICE HOW 'NICE' THE THREADS ARE INSIDE.
BOLT.JPG (63179 bytes)

THIS IS THE RETAINING BOLT,  USED IN ADDITION TO THE CAP SCREWS USED TO HOLD THE SMALLER FLANGE TO THE CAM GEAR.  CAP SCREWS NOT SHOWN,   BUT THEY TOO ARE A WORK OF 'ART'.
THREADS.JPG (54267 bytes)

CLOSE-UP OF THE THREADS ON THE BOLT.  YUCK!
 
ASSMBL.JPG (62375 bytes)

PROP FLANGE INSTALLED.
ASSMBL2.JPG (62945 bytes)