I have tried several different kinds of tag protectors and these are the best! The flat, thin, protectors that are open at the top do not prevent folding, do not prevent water from entering at the top, the tag can come out when the beanie is played with, and most importantly, do not have an internal recess. Consequently, when the tag is inserted, the stem (the red thingy that attaches the tag to the beanie baby) will be squeezed against the tag, and will eventually cause a noticeable dent on the tag. The heavier, lockettype, tag protectors do a good job in protecting the tag. However, their weight will cause stress on the fabric of the beanie. Over a period of a couple months, especially if the beanie is handled, you will notice a larger hole developing where the tag enters the beanie fabric. The tag will be protected, but the beanie will be destroyed.
The price is also very reasonable. Here are it's benefits:
| | * Heart shaped locket tag. Clear hard but lightweight plastic.
* Acid and oil free surface |
* Both top and bottom of tag made of strong 15-mil, archival quality, material , making an impressive total of 30 mils of strength) |
* Lightweight (approximately 1-20th of an ounce) |
* Has an internal recess sufficient to house the stem and tag without squeezing, has an entry slot for the stem to go through. |
* Made of absolutely acid-free, archival-quality, material, the safety of your beanie's tag is protected forever! |
* 15 cents EACH!!!! Wholesale price without having to get wholesale quantities. ORDER NOW!!!! |
