Extend your bottom time using a urine dump valve!
No
use having loads of breathing gas
if
nature prevents you from concentrating.
Long
working hours and deco times no longer a problem.
Relieve
yourself with donned dry suit!
#11900
Urine dump valve is
intended for attachment in a valve port that is permanently glued to the suit.
The urine dump valve is furnished with a pressure compensation mushroom valve
inside the internal nut. A silicone hose attached to the nut socket is
connected to an uridome..
A valve
port,
an exhaust valve with an attachment nut
furnished with a socket and a silicone hose are all included in the package
Spares
and extras:
Self-adhesive
uridomes (disposable)
(#11907
diameter 25 mm, #11908 ø 30 mm and #11909 ø 35 mm
Valve
port blank plug #60330
for dives when not using the urine dump valve
Also
available as #16900Urine dump valve low mute/non magnetic
®
Special Diving Products and
Innovation TECHnology AB.
Phone:
Int’l +46 523 15010 Fax +46 523
611511 VAT No. SE556468908001
E-mail:
orders sales@comdive.com inquiries info@comdive.com Website: http://comdive.com
Urine dump valve #11900
Suit preparations:
Attach the valve port into the suit on the upper and inner part of the thigh, minimum 15 mm from the crotch, easy to access when setting and manually dumping the valve. (A valve port blank plug may be used whenever using the urine dump valve is redundant.)
Attach
the urine dump valve into the valve port with the socket of the attachment nut
pointing upwards.
The
underwear will have to be penetrated (i.e. on the thigh) to give way for the
hose.
Assembling hose &uridome:
To ease the insertion, angle cut the
silicone hose ›45º. Insert the chamfered end through the
uridome extension. To secure the hose from slipping out, apply silicone sealant
or Aqua sure on the last 30 mm of the hose. Pull the rest of the hose until it
does not protrude into the cup of the uridome.
Adjust the length of the hose (still
allowing you to stretch your legs when swimming) and cut the end perpendicular.
Donning:
Relieve yourself before starting the
donning. The uridome is put on the same way as a condom. Make sure no hair is
snagging in the self-adhesive surface.
Put on the underwear as far as to
your thighs and put the end of the hose out through the hole in the underwear.
A good idea is to gently tape the hose to the body. Make sure you avoid sharp
bends and squeezed hose. Put on the rest of the underwear.
Put on the suit as far as to your
thighs and attach the silicone hose to the attachment nut socket. Put on the
rest of the suit.
Using:
As the dump valve is under constant
under pressure, the lid should be turned clockwise to full (+) to avoid back
leakage.
Turn the lid counter clockwise to
full (-) or push the lid towards the leg and urinate.
Don’t wait too long before relieving
yourself. It’s better to urinate often.
To minimise the pressure difference, maintain a horizontal position while urinating.
Doffing:
Open the urine dump valve lid to a
full (-).
Open the suit and underwear.
Squeeze as much urine as possible
out of the hose, from the uridome and outwards through the valve.
Disconnect the hose from the
attachment nut socket. If possible, cover the socket to avoid further
spill/leakage. Remove the uridome.
After doffing the suit, remove the dump valve, rinse it and insert
the blank plug if available. Uridomes are preferably used once only. The entire
valve and the disconnected silicon hose should be washed in luke warm soap
water and then thoroughly rinsed in cold water.
Store with the hose disconnected
after use.